LPC812M101JD20FP

The LPC812M101JD20FP is an ARM Cortex-M0+ based, 32-bit Microcontroller operating at CPU frequencies of up to 30MHz. The peripheral complement of the microcontroller includes 16kb of flash memory, 4kb of data memory, CRC engine, one I²C-bus interface, two USARTs, one SPI interface, multi-rate timer, self wakeup timer, state-configurable timer, one comparator, function-configurable I/O ports through a switch matrix, an input pattern match engine and 18 general purpose I/O pins.

• ARM Cortex-M0+ Processor, Built-in Nested Vectored Interrupt Controller (NVIC)
• System Tick Timer
• Serial Wire Debug (SWD) and JTAG boundary Scan Modes Supported
• Micro Trace Buffer (MTB) Supported
• 16kb On-chip Flash Programming Memory, 4kb SRAM
• Boot Loader
• USART Drivers
• I²C Drivers
• Power Profiles
• Flash In-application Programming (IAP) and In-system Programming (ISP)
• High-speed GPIO interface connected to ARM Cortex-M0+ IO Bus with 18 general purpose I/O (GPIO) pins
• GPIO Interrupt Generation Capability with Boolean Pattern-matching Feature on Eight GPIO Inputs
• Switch Matrix for Flexible Configuration of Each I/O Pin Function
• State Configurable Timer (SCT) with IO functions assigned to pins through the switch matrix
• Multiple-channel multi-rate timer for repetitive interrupt generation up to four programmable
• Self Wake-up Timer (WKT) Clocked from Either IRC or a Low-power, Low-frequency Internal Oscillator
• CRC Engine
• Windowed Watchdog Timer
• Analogue, Comparator with external voltage ref with pin assigned or enabled through switch matrix
• Two USART Interfaces with Pin Functions Assigned Through Switch Matrix
• One SPI Controller with Pin Functions Assigned Through Switch Matrix
• One I²C-bus Interface with Pin Functions Assigned Through Switch Matrix
• 12MHz Internal RC Oscillator Trimmed to 1 % Accuracy that can Optionally be Used as a System Clock
• Crystal Oscillator with an Operating Range of 1 to 25MHz
• Programmable Watchdog Oscillator with a Frequency Range of 9.4kHz to 2.3MHz

Anwendungen

Unterhaltungselektronik, Sensortechnik, Beleuchtung, Motorantrieb & -steuerung, Sicherheitstechnik

Hinweise

Bei Auswahl von Code Read Protection Level 3 (CRP3) können zukünftig keine werksseitigen Tests auf dem Baustein durchgeführt werden.