Low

MK20DX256VLK10 - 

ARM-Mikrocontroller, Baureihe K2 USB, ARM Cortex-M4, 32bit, 100 MHz, 256 KB, 64 KB, 80 Pin(s)

NXP MK20DX256VLK10

Abbildung ggf. ähnlich. Alle Angaben ohne Gewähr. Ausschlaggebend sind die Produktinformationen des Herstellers.

Hersteller:
NXP NXP
Herstellerteilenummer:
MK20DX256VLK10
Bestellnummer:
2133578
Produktsortiment
Kinetis ARM Cortex-M4 Microcontrollers
Technisches Datenblatt:
(EN)
Technische Dokumentation anzeigen

Produktspezifikationen

:
80Pin(s)
:
64KB
:
1.71V
:
3.6V
:
100I/O(s)
:
Kinetis ARM Cortex-M4 Microcontrollers
:
Stückweise
:
100MHz
:
32bit
:
CAN, I2C, I2S, SPI, UART, USB
:
ARM Cortex-M4
:
LQFP
:
256KB
:
MSL 3 - 168 Stunden
Finden Sie ähnliche Produkte Passen Sie die Auswahlkriterien oben an, um nach ähnlichen Artikeln zu suchen.

Produktbeschreibung

The MK20DX256VLK10 is a 32-bit Kinetis K2x Microcontroller with USB control, based on ARM Cortex-M4 RISC architecture core operates at a maximum frequency of 100MHz. The device incorporates 512kB internal flash, 68kB internal RAM, 4kB EEPROM, two 16-bit SAR A/D converter, one 12-bit D/A converter and 52 general-purpose I/O pins. This device also features communication interfaces like four UART modules, two SPI modules, two I2C modules and one I2S module.
  • ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
  • Serial programming interface (EzPort)
  • FlexBus external bus interface
  • 3 to 32MHz Crystal oscillator, 32kHz crystal oscillator and multi-purpose clock generator
  • Multiple low-power modes to provide power optimization based on application requirements
  • Memory protection unit with multi-master protection
  • 16-channel DMA controller, supporting up to 63 request sources
  • External watchdog monitor
  • Software watchdog
  • Low-leakage wakeup unit
  • Hardware CRC module to support fast cyclic redundancy checks
  • 128-bit Unique identification (ID) number per chip
  • Low-power hardware touch sensor interface (TSI)
  • Programmable gain amplifier (PGA) integrated into each ADC
  • Three analog comparators (CMP) containing a 6-bit DAC and programmable reference input
  • Voltage reference
  • Programmable delay block
  • 8-channel Motor control/general purpose/PWM timer
  • Two 2-channel quadrature decoder/general purpose timers
  • Periodic interrupt timers and 16-bit Low-power timer

Anwendungen

Industrie, Automatisierung & Prozesssteuerung

Zugehörige Produkte